Toprecision — Precision Fastening & Connection Solutions

Hydrogen embrittlement (HE) is the most insidious fastener failure: parts pass every inspection, install normally, then crack under load hours or weeks later with no warning.

Bottom line: for most Ultra-High-Strength Bolts applications the decision comes down to load, environment and assembly method — the Ultra-High-Strength Bolts guide walks through the selection.

Where the hydrogen enters

Acidic plating and pickling generate atomic hydrogen at the steel surface; it diffuses interstitially and concentrates at high-stress regions — thread roots above all. Above roughly 1,000 MPa hardness (common in 12.9 and stronger), the local hydrogen concentration can exceed the steel's threshold and initiate delayed brittle fracture.

The control chain

• Minimize acid contact time and current density during plating of high-strength parts.
• Bake within one hour of plating — typically 190–220 °C for 8–24 h depending on class — to drive hydrogen out before it traps.
• Prefer mechanical plating or zinc flake coatings for classes above 10.9; they avoid hydrogen generation entirely.

The re-embrittlement trap

Field service that re-plates used high-strength hardware recreates the risk with none of the controls — prohibit it in maintenance manuals. Topprecision applies zinc-flake systems on its high-strength range as standard, with baking records per lot and HE test documentation for safety-critical applications.

Key specifications at a glance

Need help selecting the right fastener material?

Toprecision cold-heads and CNC-turns fasteners in steel (4.6–12.9), stainless 304/316/410, aluminum 6061/7075, titanium Grade 5 and engineering plastics. Send the service environment and load requirement — we will recommend the material and grade with tensile test data. Request material selection support.